You are here: Maintenance > Operator Routine Maintenance
Operator Routine Maintenance
Daily
- Clean the Print Heads (do this first thing before your shift).
- Replace the Dust Extractor Bags if full.
- Inspect the Waste
- Blow down the Saw Chamber and the Feeders.
- Be on the look-out for anything that appears incorrect or loose.
- Clean the floor around the machine.
Weekly
- Clean and inspect the Saw Chamber Door.
- Inspect the Follower for any loose, damaged or faulty components.
- Inspect and clean the Feeder Sensors.
- Inspect and clean the Feeder Drive Rollers (steel bottom ones).
- Shake the dust out of the top Dust Filter Bags.
- Blow down the Saw Chamber (including the top) and the Feeders.
Monthly
- Grease all bearings (Y and Z‑axes, Feeders
- Check the AIT chain tensions (4 side transfer chains and 1 roller conveyor chain).
- Clean any grime off the Follower's horizontal steel linear rail using a small amount of WD40 on a rag. (only applicable to pre‑September 2016 non‑Rexroth Followers –
- Take the caps off the ends of the Follower's linear module and blow the dust out of it. (only applicable to post‑September 2016 Rexroth Followers)
- Inspect the Feeder Nylon Rollers (4 top and 12 side).
- Clean the Fan Filters and Electrical Cabinets.
- Blow down the entire machine.